Fuel Pressure Regulator

[Ldub]

Hmmmmm ...PB blaster?

[etlsport]

what about taking an allen wrench and cutting the end off of it (so its just a straight hex key) and then using a regular 6mm crescent wrench to turn that?

[Dino]

what about taking an allen wrench and cutting the end off of it....

Yeah.. but like the pics below perhaps.

You could also grind it down on a bench grinder. A Hacksaw will not cut it so don't even try that.

A short 6mm allen really is handy for this.









Here's the whole thread that the pics are from.
Lots of pics so it may load slow. I replaced the rear bolt with a 12mm hex head.

[JHarris1385]

I used a non cut allen, then stuck the extension handle from my small floor jack over it. USE PB BLASTER

[etlsport]

yep thats where the idea came from... being short makes it harder to reach in there and pull the allen wrench out each time.... so its easier for me to use be able to put it back there once and then just use a crecent wrench from there same basic idea though... btw thanks for the write up dino... finally gave me the guts to tackle the project.. been puttin it off for like a year