You can also get vehicle logo decals, maybe I will get a large "VX" in white for the hood insert
You can also get vehicle logo decals, maybe I will get a large "VX" in white for the hood insert
For sure, Kevin aims to do what ever it takes to Git R Done. If the quality of the product is as good as the customer service, you can't go wrong. I also asked if there a install sheet for the decals. There aree tricks to the trade and I don't know what they are. For sure what them to stay on after the first wash and want them centered.
As for vinyl, all you would have to do is mix a mild dish soap and water solution and spray a thin film on the center cap, then apply vinyl, and squeegee the airbubbles and extra water out from under it. let dry, and it should be good to go. never had a problem with them peeling off.
(never installed on center cap, just body graphics or windshield visors)
Originally Posted by rowhard
01 VX Kaiser | Love it! Drive it! Mod it! MYVEHICROSS.com | VX-WIKI
Rancho RS9000X | VXC Shifter Plates | PV2 | Hella Micro DE fogs | Carbon Fiber Hood | AfterShock Skid Plates (front, rear, sides)
Rowhard,
Thanks for making us aware of these. I just ordered the "VX" logo in yellow with the black background.
I did this during the game...
Henry
they arent hard to put on, i used a spray bottle with tap water and dish soap in it, sprayed the caps, scrubbed with a paper towel, sprayed distilled water on them, wiped off, wiped them with the wet paper towel then used the squegee to press the middle of the sticker into the wheel, and squeegeed down to get the bubbles out, then up for the top.. then dug my fingernails into the gap between the centercap and the logo (theres a very fine crack) and used that as my guide to cut the vinyl with an exacto blade.. any air bubbles i poked with a needle and squeegeed in the area
k4tmc, yellow on black, that should really look cool on your proton. I ordered the Chrome VX on Carbon. But now that it is avaliable, can always change later.