isnt revese signal is only one wire?
Super VXer
isnt revese signal is only one wire?
Super VXer
You should be able to run it right off of the backup lights in the rear. The only problem is that the front would remain on all the time unless you found the reverse wire up front like AndyC said. Another issue with doing it that way is that the screen takes a second or two to turn on, get set up, and adjust the brightness. It also isn't that great for using just as a backing up camera due to its wide angle. You can see a lot to the sides, but the depth perception is piss poor in this thing. I know that sounds kind of contradictory, but it is pretty hard to use for say backing up into a trailer or parking spot, etc.
The reasonable man adapts himself to the world; the unreasonable man persists in trying to adapt the world to himself. Therefore all progress depends on me.
Super VXer
well my camera connected to my back up lights and i didnt figure out yet where im going to connect my screen because its 2 wires red and black which mean positive and ground and reverse signal is only one wire red w/yellow stripe so it would be what?
I installed my camera into VX stock hole and i can see a little peace of my body so i know exacly how close i am to the other car and thats what i was looking for.
Posting Permissions
Reply With Quote