Nevermind my last post, this from Wikipedia:

"PCV system
The PCV valve is only one part of the PCV system, which is essentially a variable and calibrated air leak, whereby the engine returns its crankcase combustion gases. Instead of the gases being vented to the atmosphere, gases are fed back into the intake manifold, to re-enter the combustion chamber as part of a fresh charge of air and fuel. The PCV system is not a classical "vacuum leak." Remember that all the air collected by the air cleaner (and metered by the mass air flow sensor, on a fuel injected engine) goes through the intake manifold anyway. The PCV system just diverts a small percentage of this air via the breather to the crankcase before allowing it to be drawn back in to the intake tract again. It is an "open system" in that fresh exterior air is continuously used to flush contaminants from the crankcase and into the combustion chamber.

The system relies on the fact that, while the engine is running, the intake manifold's air pressure is always less than crankcase air pressure. The lower pressure of the intake manifold draws air towards it, pulling air from the breather through the crankcase (where it dilutes and mixes with combustion gases), through the PCV valve, and into the intake manifold.

The PCV system consists of: 1) The breather tube , and 2) The PCV valve. The breather tube connects the crankcase to a clean source of fresh air, such as the air cleaner body. Usually, clean air from the air cleaner flows in to this tube and in to the engine after passing through a screen, baffle, or other simple system to arrest a flame front, to prevent a potentially explosive atmosphere within the engine crank case from being ignited from a back-fire in to the intake manifold. The baffle, filter, or screen also traps oil mist, and keeps it inside the engine.

Once inside the engine, the air circulates around the interior of the engine, picking up and clearing away combustion byproduct gases, including a large amount of water vapor, then exits through a simple baffle, screen or mesh to trap oil droplets before being drawn out through the PCV valve, and into the intake manifold."

So, basically, what we are doing, is sort of bypassing the whole PCV system process? Is that correct? With the hose that leads back into the intake blocked off, does this cause any issues? Or is it ok for the main intake to be used fully?

My problem is that I am not understanding the point of the PCV system if it should just be vented off instead of fed back into the intake. Is this just a serious design flaw with this particular PCV system on Isuzu's part? Is it basically that the existing PCV configuration is not functioning properly (i.e. not venting or getting clogged)?

I have been changing my PCV with EVERY single oil change, and my oil consumption has not gotten any better....

Sorry for all these questions, just trying to learn this stuff so I have a solid understanding....

Thanks - Bart