I have taken a pic from the vx manual and hope that it will help. where the blue circle is you connect the breather.Just get a short piece of hose and a couple clamps. Or you can get one the same size as the hole for the pcv valve and just remove the pcv valve and install the breather in the valve cover. Second step would be to plug the hose circled in purple.Again I used a short piece of hose and I plugged it with a bolt, again using clamps on the hose.Or you can just plug the stock hose with a bolt and use a clamp. If you use a hose on the pcv valve put the breather pointing toward the front . It will be covered by the plastic cover and you will not see it.The pcv valve is in the drivers side valve cover. Hope this helps. As soon as I can I wil post an actual pic. Right now we are getting hit with a pretty big snow storm. hopefully enough to open the snowmobile trails. shawn