Printable View
So, I'm learning how to weld and naturally the first project was the brush guard. I may change or remove the top bar, but here it is. Next is a matching one for the back. It looks wide, but is just as wide s the fenders and the Mrs. has authorized larger tires this week......all I have to play with is $500 though :(
http://www.vehicross.info/gallery/da...s/IMGA0919.JPGhttp://www.vehicross.info/gallery/da...s/IMGA0920.JPG
Cool, can't wait to see the pics.
Your VX is taking on a look of raw strength - is it possible for you to use a bigger diameter material for this brushguard? I think it would blend with what you have going on... in other words... I am excited to see where your VX goes! Harbor Frieght has a pipe bender for around $100 and it can bend tubing if you plan ahead to use a die that works well with a specific size of tubing. Pipe and tubing differ in their measurement of inner dia. and outer dia. If your wife would allow you to budget this bender into the plan you could take on something to school everyone in the budget buildup dept that looks great! Or just use a bigger diameter material and go with it but.. sorry, personally I think the diameter is a bit small. I am liking your VX's direction though!
Harbor freights bender aint worth the cans its cast from.. Dont even think about using it as a tubing bender. it is a pipe bender, and there is a big difference.
Just a word or advice from one welded/fabricator to another, brace the lower and middle tubes with something alone the ends. If you hit anything substantial that will bend and pierce the headlight/fender area. Otherwise it looks pretty good, no how about some close ups on the welds????http://img.villagephotos.com/p/2003-5/195531/welder.gif
Here is your closeup on the welds. I cannot take credit though. My neighbor is taking welding classes, so I just tacked everything up and he finished it up much better than I can right now. I am still using flux core so it's ugly, but I have my gas setup on order, then we'll see where I am at.
As for the pipe size, it is 1 inch and actually looks bigger and more substantial in person. That being said, I may do it again with 1.5-2" pipe. I just don't like the big "nerf bar" look. I think it distracts too much from the truck. I am still not too keen on the upper bar as it covers the grill. I also have to do the back guard.
http://www.vehicross.info/gallery/da...uard_close.JPG
After leaving it for a week, I decided I didn't like the top bar, so I cut it off.
The new tires are just some relatively cheap off brands, "made by Goodyear" that I got a good deal on. I think I'll bedliner the rims soon....
http://www.vehicross.info/gallery/da...s/IMAG0002.JPGhttp://www.vehicross.info/gallery/da...s/IMAG0001.JPG
Looks 10x better......How much $ did this cost you?
$15 in black pipe, $3 for a new sanding wheel for my cheapo angle grinder,$5 new blade for the sawzall,I had the angle iron, some MEK for cleaning and the spray on truckbed liner (any other textured paint would have worked fine too), $15 bottle of vodka to get my neighbor to finish the welding that I tacked in place and a six pack, while the paint dried.
Is that a sticker from Robocop? OCP?Quote:
Originally Posted by MustangO3
"Dead or alive, you're coming with me."
yes