Printable View
OK folks,
Post Moab, I have discovered that my VX now makes an audible popping noise, when backing up with my wheels cut to the left. I am thinking CV shaft but wanted some input here. The noise seems to be coming from the right side, underneath, and seems to be under the passenger side door toward the front end. Again, the noise only happens in reverse, and only with the wheels cut to the left more than half way.
Any ideas?
Thanks - Bart
From my experiance with cv's I would say if it doesnt happen when you make a u-turn then it probly isnt them
How 'bout a dust flap in the wheel well catching on your tire treads?
:confused:
Good Luck.
I don't I have dust flaps... :)
Bart
Quote:
Originally Posted by Kenny
you know, the plastic fender liners... but if that's not it, I'm thinkin' CV time. I'd be inclined to swap both entire axle assemblies, than do the CV's themselves. I don't know for sure on our car(have not had need) but it is the easy way out most times
Well, I don't really have much to go on yet other than this sound. Driving the VX does not seem any different. No noises going forward, no vibrations, nothing.
Bart
Quote:
Originally Posted by Chopper
Bart,
Have you checked your CV boots real close ?
No sir, not yet. What should I be looking for? I have been underneath 3 or 4 times since returning from Moab, and I did not seen anything weird (leaks, etc).
Bart
Quote:
Originally Posted by Ldub
The conical rubber boots on either end of the half shaft (between the front third member & the hub (back side of where front wheel bolts on).
Check them all around for tears/evidence of grease.
If one had a tear, it might possibly make a popping noise as it rotates...that's about all that comes readily to mind.
Good Luck. :cool:
Turn up volume on stereo...no more noise...problem solved! :bwgy:
Yeah, that's why I don't think I heard the noise until just last week. I usually have the Zen blasting through my stereo.
Bart
Quote:
Originally Posted by Triathlete
Do you turn you head to look when you're backing? Chiropractor??? :p :rolleyes:Quote:
Originally Posted by nfpgasmask
Today I rolled around under my VX in search of anything abnormal looking and I found nothing. The CV boots look fine, no leaks or cracks. So, I am at a loss, but at the same time, not overly worried...
Bart
CHECK THE BOLTS OF YOUR SUSPENSION!!!!!!!!!!
These tend to come loose sometimes, and it makes a cluking noise when backing up!
Thanks Dutchguy! But, could you be a little more specific with which bolts? I am just about worthless under there....so I need pictures or very accurate descriptions of where to look!
Bart
Quote:
Originally Posted by thedutchguy
These are the bolts which hold the shims for the allignment of the wheels.
They are always under tension because of the spring load caused by the torsion springs of the suspension. But when they become loose, backing up the car results in enoug momentum to push the suspension back into place.I added a drawing of the suspension.
I mean bolts nr.158!
http://www.vehicross.info/gallery/da...sion_front.JPG
Thanks man! I will check this out for sure!
Bart
Quote:
Originally Posted by thedutchguy