greg- looks awesome! doesnt really surprise me though after the amazing job you did on our skid plates.... once again, you did it right....
Printable View
greg- looks awesome! doesnt really surprise me though after the amazing job you did on our skid plates.... once again, you did it right....
Because I am jealous of this bumper and want one! And everyone should see this and dream up some new possibilities for the front and rear. It is possible to do.....
here she is ready for priming.
http://www.vehicross.info/gallery/da.../100_04351.jpg
all painted, turn signal lights in.
http://www.vehicross.info/gallery/da.../100_04381.jpg
license plate holder in, forgot to get picture with the hook in it.
http://www.vehicross.info/gallery/da.../100_04361.jpg
http://www.vehicross.info/gallery/da.../100_04371.jpg
next i need to get a lower skid plate, then I'll start fitting the lower bumper.
That is just looking incredible! Way to go!:thumbup:
What is the rough weight?
Looks good Orion. Are you going to add any gusseting to the rear and mount?
I'm guessing around 50 lbs tops. i meant to weight it, I'll take it off and check.
no gusseting needed, the mount plates are 1/2 in thick and welded thick. the receiver is welded on both sides.
Greg...that's pure sweetness...:thumbup:
JOB WELL DONE ! ! !
:yes:...:LineWave:...:yes:
looks great you going to do the back now???
That's just sick...
Nicely done :clap:
I like it too.
Great job! Would you tell us the length of each section is and what degree of bend you used for each?
Peace.
Tom
Hat's off ! ! ! Looks Great ! ! !
I want one of those.... but with a winch mount too!! That ROCKS!
Excellent job!