I had to reseal klearz sidemarkers before I put them on - just blow some shop air into - to see all holes at where lenz glued to base.
Printable View
Please note GMC SAVANA turn signal lenzes are different PN# for left&right side!!!
http://f1.foto.rambler.ru/preview/r/...turnsignal.jpgGMC Savana clear lenz assy on VX
front end view
http://f4.foto.rambler.ru/preview/r/.../front_end.jpg
one more time
http://f1.foto.rambler.ru/preview/r/...ignal_lenz.jpg
and yellowish KLEARZ sidemarker
http://f1.foto.rambler.ru/preview/r/...590/klearz.jpg
Thanks for the link and good info. Seems like the quality might not be worth the price. I was talking to Jason (making knobs) and he thought he might also be able to make clear lenses. Could be an better option?
On a side note: I like the bumper Dmitrikr. :thumbup:
I've been thinking about something similar but with the square tubing embedded into the cladding so I keep my approach angle. This pic helps me get a visual, thanks.
http://f4.foto.rambler.ru/preview/r/.../front_end.jpg
VXorado,
I like GMCs turn signals, but don't know who is making good sidemarkers.
front bumper- off the police cruizer little bit modified to fit- not all the time on truck - just when I need to push dead car in the shop. That's why it is so low up front so I can use it for small cars as well.It has thick rubber padding up front so no scratches on other car's bumper.
Third set installed by Lic plate.
http://i1265.photobucket.com/albums/...ps2dea5dd0.jpg
All the grilles used are from Vx rear panels
http://i1265.photobucket.com/albums/...ps095eb1ef.jpg
Next the center grille.... planning on leaving the fangs on. So it will be a three piece unit. Haven't chosen the material yet.
I did finally get the last 3 grille pieces done. There are now 9 different inserts in the front end.
http://i1265.photobucket.com/albums/...psda45a9f4.jpg
http://i1265.photobucket.com/albums/...psd7ace767.jpg