switch question

hey I'm new. Just another question on the t.o.d. switch. Do I just run a toggle on the blue wire under the seat so the wire doesn't complete a circut or is there more to it than that? I just dont want to mess anything up.
One last question, Is there also a way to make the tranny work in a locked 4x4hi mode. thanks

(corrected me if im wrong) all you have to do is disconnect the blue wire to make disable TOD...i havent done it yet, cause i dont have a switch but its suppose to work like tat....

in THEORY, since the blue wire controls the front silinoid(sp?) if u get it to engage the whole time then ull have 4x4hi...so basically hook up power to it....but u wont have locked difs tho..i think...

if u really want to do this 4x4hi then i think ull be the first....;Dy;
________
Child nexium

Before you go and apply the wrong power to the tod solenoid in an attempt to go full time 4-hi, you might want to probe the wires to find out if you need 12 or 5 volts or PWM.

so is the blue wire going into the computer, or out of the computer and out the floor. I think I have this covered. Now is it possible to put on manual front hubs so the drive shafts dont spin in 2 wheel.

u might want to do a quick search...theres afew ppl tat have done it....and they can probably help u.....i think it was yesterday i was reading a few post about puttin a load on the wire so the tod computer things its still connected to the front soleniod....something about a switch with a led or soemthing...
________
WASHINGTON MEDICAL MARIJUANA DISPENSARIES

Dustin, sending you an email.

I think this will answer all your questions...
http://www.planetisuzoo.com/articles.htm/109