Printable View
Was reading new issue of Truck Trends with a article on the new Direct Injection 2004 Axiom motor which adds about 10% and better gas mialage...
NICE! drops the 0-60 a full second down to 7.6
and 1/4 mile @ 15.4@90.9
this is going to be faster than my VX with the S/C... blah
Wonder if this motor has anything we can steal from it for our VXs?
-Dave
Crate an Axion engine in and lets hoist it into the VX. I am all for it. ;)
How much does a new axiom engine go for...and is it a direct drop into our vx?..
________
Mutual Care Foothill Ranch
15.4? damn...how heavy is the axiom? if it's heavier than VX that'll be even better.
If you did this, you'd need to bring the Axiom computer over as well... or try and reprogram the VX computer.
I know this has been brought up before, and Andy chimed in a bit with some interesting statements.
You would need a complete wiring harness as the axiom uses etc. You would also need a new pedal and due to the direct injection you would need a new fuel system. It works off of very high line pressure so the pump and lines would be different. New pcm also. It could be done though
hmm.....ecu swap isnt too complicated...ive done a few civics but the wiring might get tricky...also is the engine mounts the same or does it require some modifications to fit it in? last thing anyone know how much a used 04 axiom engine would cost?
________
Club Royal Condo Wong Amat
Some articles of interest I found on the D.I. Engine:
http://www.edmunds.com/news/autoshow...9/page012.html
http://www.popsci.com/popsci/bown/20...534655,00.html
http://biz.yahoo.com/prnews/031107/laf008_1.html
http://waw.wardsauto.com/ar/auto_isuzus_turnaround/
http://classifieds.dallasnews.com/au...m.6c15b15.html
http://www.laautoshow.com/highlights_isuzu.asp
http://www4.fosters.com/autos/articl...o_1121_03j.asp
"The company announced the planned introduction of an all-new SUV in 2006. Isuzu intends for the vehicle to offer three rows of seating and will be powered by the same 3.5-liter direct-injection engine that will appear standard in the 2004 Axiom and as an option in the 2004 Rodeo."
Replace TOD with hard xfer case, install manual wheel locks, do some elementary hot rod tricks, firmup bottom end and u get same results without the walking the thin ice wizardry
Please Post plenty of pics when your done!Quote:
Originally posted by VX922
Replace TOD with hard xfer case, install manual wheel locks, do some elementary hot rod tricks, firmup bottom end and u get same results without the walking the thin ice wizardry
Found this to be very much "Food for Thought" when concerning a major engine swap such as to the Chevy LT-1.Quote:
Originally posted by skunkworks
However, in this day and age you have to be mindful of your emmission laws. If you have mandatory tailpipe testing in your area, or the prospect of it being put in place then your VX could be illegal to drive on the street or license. According to CARB rules which most states and feds copy, if the receiving vehicle is covered by emission regulations, no matter how clean it is, before it can be tested the swap has the meet several critiera. First the new motor has to be the same year or newer than the vehicle. Second the motor needs to be of the same family as the veihcle. I.E. no Ford into Chevy ect. Now, with the Hombre being sold as an Izuzu, a 4.3 would be legal but not another GM motor not sold as a Izuzu.
If you can get past all this, then you go to arbitration and are then at the whim of a bureaucrat. There is also this old thread. Good luck.
http://myweb.cableone.net/bcanderson...uroraSwap.html
albert
Would really like to know about this! Could be a viable option for those of us wishing to remain with the 3.5L should we encounter a terminal problem with our present powerplant.Quote:
Originally posted by SGT.BATGUANO
How about getting the direct injection shortblock and using that with your old top end? Is that new block a new revision and are our heads etc., a direct interchange? I don't know, but you could try contacting andy454 or Anita's Isuzu service person.
Same...only location of fuel injectors has changed to directly firing into cylinders.Quote:
Originally posted by MZ-N10
also is the engine mounts the same or does it require some modifications to fit it in?