Texas (Fort Worth area) machinist recommendations

[Y33TREKker]

Anyone in the Fort Worth, Texas area know of any good machinists you could/would recommend for being a supplier for another local parts specialist?

The parts specialist is currently in need of another supplier for the two-piece clamp described in the attached .jpg, and if you've actually had experience and good results, your recommendation would be appreciated.

And this request is for any VX members here. The clamps are currently shipped to the specialist, so being local to the Fort Worth area isn't an absolute necessity. Their current supplier simply isn't proving to be a reliable source.

http://www.vehicross.info/gallery/data/500/medium/PKlamp.jpg

[kach22i]

You might get some help in this other forum I frequent.

I post in the 911 section, but assume the 928 guys are just as helpful.

http://forums.pelicanparts.com/porsche-928-technical-forum/

Even a bigger audience in the OT (Off-Topic) section.

http://forums.pelicanparts.com/off-topic-discussions/

[JoFotoz]

PM'd you with a contact in Texas.
He's a 928 guru..owns a 'flock' of them.

Jo

[Y33TREKker]

Thanks kach. I've been getting a few responses on various message boards, so if no alternatives present themselves there I'll expand the request list.


You might get some help in this other forum I frequent.

I post in the 911 section, but assume the 928 guys are just as helpful.

http://forums.pelicanparts.com/porsche-928-technical-forum/

Even a bigger audience in the OT (Off-Topic) section.

http://forums.pelicanparts.com/off-topic-discussions/

[Y33TREKker]

Thanks jo. I've sent your contact a message.


PM'd you with a contact in Texas.
He's a 928 guru..owns a 'flock' of them.

Jo