PDA

View Full Version : Possible TOD problem



BritVX
02/14/2010, 11:41 AM
A friend has just bought a JDM VX having seen mine, but having picked it up he’s worried about a noise. We took it for a run and we found the noise only occurs in 4WD when you take your foot off the gas, it sounds like a warn diff’ drone but doesn’t occur in 2WD or 4 Low, under acceleration or braking. It’s only done 25K but the dealer says it’s been stood for over a year. There is the chance it will just go as he runs it but I think he should have the dealer check it out.
Your thoughts please guys
Cheers
Col

Greasemonkey
02/14/2010, 11:47 AM
99/100 a noise on over run is a cv joint mostly the inner one - give them a good wiggle i am sure you'll find the one thats making the noise
cheers
Steve

Sprey
02/14/2010, 04:50 PM
Also at what speed? when i let off the gas say doing around 100kmh, i get a little bit of dif noise but as soon as i put on the gas a tad again it goes away.

normaly after greasing up the driveshaft ( 3 spots) vibration goes away

p_justin13
02/15/2010, 05:06 AM
Mine is having the same issue, between 25 and 40mph especially give a whirring noise as it decelerates. The tod display on the front wheel lights up from the first bar to the third in sequence with the noise but goes away as I accelerate again. Greased driveshaft was thinking axle bearings or pinion gear in the front end?

ZubrAZ
02/15/2010, 08:14 AM
^^^ same issue, only at higher speeds - around 50-60mph. dont have an idea what to do to fix :(

BritVX
02/15/2010, 09:13 AM
Thanks for the come backs, interesting to note a few have a similar noise but I think the CV joint could be on target, I'll get him to check it.

Thanks

Col

ZubrAZ
02/15/2010, 10:11 AM
Sprey, what are those spots to grease?

Amnesia
02/15/2010, 04:55 PM
Mine has howled like a banshee for the past 150,000 miles since I bought it with around 31,000 miles on it... under normal load at highway speeds. Very light (almost neutral) acceleration & it's quiet, but as soon as I'm on the gas very much at all it just drones on & on.

Good luck.

Sprey
02/15/2010, 07:44 PM
Sprey, what are those spots to grease?
heres a video
Cheers to Etlsport for the video.

http://www.youtube.com/watch?v=rzaNXz-ty34

ZubrAZ
02/16/2010, 09:47 AM
wow! thank you very much, Sprey, and big-big thanks to Etlsport.

additional question: what type of grease should I use?

i feel weirdly: i was able to change the engine in my VX, but seems im asking such lame questions :) i pretty much dont know anything about 4wd, at the same time, I can follow the instructions with no problems at all

p_justin13
02/17/2010, 01:21 PM
Moble 1 syn. for greasing the shaft best bet
quieted mine down quite a bit but front end noise is killing me