PDA

View Full Version : quick brake question


pbkid
10/01/2009, 05:25 PM
hey guys, started replacing my brakes last night and i found that i dont have the correct size wrench to get the calipers off.... does anyone know what size those two bolts are that hold the caliper to the swing-arm?

i dont really wanna buy a whole 'large diameter' set just to get these two bolts off....

thanks guys
blacksambo
10/01/2009, 07:10 PM
I just didi my rears, and I believe it was a 9/16's eight point that I used, half-inch drive. I know it's really a metric size but that seemed to work. Let us know how you make out.
pbkid
10/01/2009, 07:23 PM
i know its bigger than 18mm because thats the biggest i have and it wouldnt fit...
Ldub
10/01/2009, 08:54 PM
Jack,

You don't need to take the whole caliper off the axle, just the part that contains the pads. The bolts are on the inboard side, & have a little rubber cover under the head...:_wrench:...:yesgray:
castigan
10/02/2009, 12:47 AM
22mm
pbkid
10/02/2009, 02:34 PM
Jack,

You don't need to take the whole caliper off the axle, just the part that contains the pads. The bolts are on the inboard side, & have a little rubber cover under the head...:_wrench:...:yesgray:

the two bolts with 'dust covers' on them?? on the back outside of the caliper? on other vehicles i have worked on you had to remove the entire caliper. those were just there to help you loosen the piston


22mm

nice, thanks! :thumbup:
Greasemonkey
10/04/2009, 02:00 AM
http://i70.photobucket.com/albums/i101/greasemonkey_01/DSCF0106.jpg
http://i70.photobucket.com/albums/i101/greasemonkey_01/DSCF0107.jpg
http://i70.photobucket.com/albums/i101/greasemonkey_01/bert007.jpg
http://i70.photobucket.com/albums/i101/greasemonkey_01/CorsaCfrontbrakecaliper.jpg
http://i70.photobucket.com/albums/i101/greasemonkey_01/CorsaCfrontbrakecaliperfoldedup.jpg
http://i70.photobucket.com/albums/i101/greasemonkey_01/FronteraBravafrontpads.jpg
pbkid
10/04/2009, 12:35 PM
nice, thanks.... good to know...

you guys are the best! :thumbup: