VX-157
06/09/2009, 04:26 PM
http://www.rhinorack.com.au/Vehicle_HONDA_Odyssey_3838.aspx
I have these on my vx now. a little adjusting to get them to fit. Mainly trimming the rubber foot on the claw. Also the underneath of the croos bars need about 2.54 cm (inch) removed on either side to accommodate the roof width.
The front feet need a little chamfer to the base but other wise a good set of racks.
There is a little air gap between the rails and the feet but i have yet to hear wind noise.
Thought some of me mates would like to have squiz at these lil beauty's.
Have a look in my galley, you can clearly see how well they suit the beastie
I have these on my vx now. a little adjusting to get them to fit. Mainly trimming the rubber foot on the claw. Also the underneath of the croos bars need about 2.54 cm (inch) removed on either side to accommodate the roof width.
The front feet need a little chamfer to the base but other wise a good set of racks.
There is a little air gap between the rails and the feet but i have yet to hear wind noise.
Thought some of me mates would like to have squiz at these lil beauty's.
Have a look in my galley, you can clearly see how well they suit the beastie